Buick Encore: Frame and Underbody
READ NEXT:
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
REPAIR INSTRUCTIONS
FRONT COMPARTMENT FRONT CENTER INSULATOR REPLACEMENT
Fig. 1: Front Compartment Front Center
Removal Procedure
Support the radiator and condenser from above using the upper brackets
on each side.
Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle .
Remove the front t
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Remove the front tire and wheel assembly. Refer to Tire and Wheel
Removal and Installation .
Remove
SEE MORE:
BODY WATERLEAK REPAIR
Fig. 6: Cutting Out A Portion Of The Adhesive Caulking (1 Of 2)
WARNING: If the vehicle interior is exposed to moisture and becomes
soaked up to
the level of the sensing and diagnostic module (SDM), the SDM and SDM
harness connector must be replaced. The SDM could be activat
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
SCHEMATIC WIRING DIAGRAMS
WIPER/WASHER WIRINGSCHEMATICS (ENCORE)
Front Wiper/Washer Control and Wiper
Fig. 1: Front Wiper/Washer Control and Wiper
Rear Wiper/Washer Control and Wiper
Fig. 2: Rear Wiper/Washer