Buick Encore: Floor Mats
Warning
If a floor mat is the wrong size or
is not properly installed, it can
interfere with the pedals.
Interference with the pedals can
cause unintended acceleration
and/or increased stopping
distance which can cause a crash
and injury. Make sure the floor
mat does not interfere with the
pedals.
Use the following guidelines for
proper floor mat usage.
- The original equipment floor
mats were designed for your
vehicle. If the floor mats need
replacing, it is recommended
that GM certified floor mats be
purchased. Non-GM floor mats
may not fit properly and may
interfere with the accelerator or
brake pedal. Always check that
the floor mats do not interfere
with the pedals.
- Do not use a floor mat if the
vehicle is not equipped with a
floor mat retainer on the driver
side floor.
- Use the floor mat with the
correct side up. Do not turn
it over.
- Do not place anything on top of
the driver side floor mat.
- Use only a single floor mat on
the driver side.
- Do not place one floor mat on
top of another.
The driver side floor mat is held in
place by a button-type retainer.
.gif)
Removing and Replacing the Floor Mats
- Pull up on the rear of the floor
mat to unlock the retainers and
remove.
- Reinstall by lining up the floor
mat retainer openings over the
carpet retainers and snap into
position.
- Make sure the floor mat is
properly secured in place.
Verify the floor mat does not
interfere with the pedals.
READ NEXT:
Your vehicle is an important
investment. This section describes
the required maintenance for the
vehicle. Follow this schedule to help
protect against major repair
expenses resulting from neglect or
i
Owner Checks and Services
At Each Fuel Stop
Check the engine oil level. See
Engine Oil
Once a Month
Check the tire inflation
pressures. See Tire Pressure
Inspect the tires for wear. See
Tire
SEE MORE:
NOTE: Examples used in this article are general in nature and do
not necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine overhaul process. Descriptions of processes
of cleaning, inspection, assembly and machine shop pract
The rear outboard head restraints
can be removed if they interfere with
the proper installation of the child
restraint.
To remove the head restraint:
Partially fold the seatback
forward. See Rear Seats
Press both buttons on the head
restraint posts at the same
time, and pull up on the hea