Buick Encore Owners & Service Manuals

Buick Encore: Schematic wiring diagrams

Buick Encore 2012-2019 Service Manual / Accessories & Equipment / Object Detection and Pedestrian Protection / Schematic wiring diagrams

OBJECT DETECTION WIRING SCHEMATICS (ENCORE)

Lane Departure Warning (UFL)

Fig. 1: Lane Departure Warning (UFL)
Fig. 1: Lane Departure Warning (UFL)

Rearview Camera (UVC)

Fig. 2: Rearview Camera (UVC)
Fig. 2: Rearview Camera (UVC)

Front Sensors (UD5)

Fig. 3: Front Sensors (UD5)
Fig. 3: Front Sensors (UD5)

Rear Sensors (UD5 or UD7)

Fig. 4: Rear Sensors (UD5 or UD7)
Fig. 4: Rear Sensors (UD5 or UD7)

Side Object Detection (UFT)

Fig. 5: Side Object Detection (UFT)
Fig. 5: Side Object Detection (UFT)

OBJECT DETECTION WIRING SCHEMATICS (Encore)

Rearview Camera (UVC)

Fig. 6: Rearview Camera (UVC)
Fig. 6: Rearview Camera (UVC)

Rear Sensors (UD7)

Fig. 7: Rear Sensors (UD7)
Fig. 7: Rear Sensors (UD7)

    READ NEXT:

     Object Detection and Pedestrian Protection - Diagnostic information and procedures

    DTC B094C: Right side object detection control module DIAGNOSTIC CODE INDEX Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Rev

     Object Detection and Pedestrian Protection - Repair instructions

    Rear object alarm control module replacement Fig. 8: Rear Object Alarm Control Module Rear Object Alarm Control Module Replacement FRONT OBJECT ALARM SENSOR HOUSING REPLACEMENT Remove the fron

     Object Detection and Pedestrian Protection - Description and operation

    OBJECT DETECTION DESCRIPTION AND OPERATION (REARVISION CAMERA, UVC) Rear Vision Camera System Operation The rear vision camera system consists of a video camera located at the rear of the vehicle and

    SEE MORE:

     Engine controls and fuel - 1.4l - Repair instructions

    Brake pedal position sensor learn Calibration Criteria NOTE: Do not apply the brake pedal during the brake pedal position sensor calibration procedure. Any movement of the brake pedal during this procedure will cause the calibration procedure to fail. If this occurs, the brake pedal position senso

     Universal Remote System Operation

    Using the Universal Remote System Press and hold the appropriate Universal Remote system button for at least one-half second. The indicator light will come on while the signal is being transmitted. Erasing Universal Remote System Buttons Erase all programmed buttons when vehicle ownership is termina

    © 2020-2025 Copyright www.bencore2.com