Buick Encore: Engine Exhaust
Warning
Engine exhaust contains carbon
monoxide (CO), which cannot be
seen or smelled. Exposure to CO
can cause unconsciousness and
even death.
Exhaust may enter the vehicle if:
- The vehicle idles in areas
with poor ventilation
(parking garages, tunnels,
deep snow that may block
underbody airflow or tail
pipes).
- The exhaust smells or
sounds strange or different.
- The exhaust system leaks
due to corrosion or damage.
- The vehicle exhaust system
has been modified,
damaged, or improperly
repaired.
- There are holes or openings
in the vehicle body from
damage or aftermarket
modifications that are not
completely sealed.
If unusual fumes are detected or
if it is suspected that exhaust is
coming into the vehicle:
- Drive it only with the
windows completely down.
- Have the vehicle repaired
immediately.
Never park the vehicle with the
engine running in an enclosed
area such as a garage or a
building that has no fresh air
ventilation.
Running the Vehicle While Parked
It is better not to park with the
engine running.
If the vehicle is left with the engine
running, follow the proper steps to
be sure the vehicle will not move.
See Shifting Into Park and
Engine Exhaust
READ NEXT:
The selected gear is also shown in
the instrument cluster.
P : This position locks the drive
wheels. Use P (Park) when starting
the engine because the vehicle
cannot move easily.
Warning
It is dang
The Antilock Brake System (ABS)
helps prevent a braking skid and
maintain steering while
braking hard.
ABS performs a system check when
the vehicle is first driven.
A momentary motor or clicking noi
SEE MORE:
Locks
Locks are lubricated at the factory.
Use a de-icing agent only when
absolutely necessary, and have the
locks greased after using. See
Recommended Fluids and
Lubricants
Washing the Vehicle
To preserve the vehicle's finish,
wash it often and out of direct
sunlight.
Caution
Do not use petroleum-
Fig. 14: Lock Cylinder Components - Ignition
The ignition lock cylinder uses 8 key cut positions, 1-8. The ignition
cylinder tumblers (3) are located on alternate sides of the cylinder (5). They
are not snap-in and are not self-retaining. It follows the key code with
the first tumbler being the