Buick Encore Owners & Service Manuals

Buick Encore: Lap-Shoulder Belt

All seating positions in the vehicle have a lap-shoulder belt.

The following instructions explain how to wear a lap-shoulder belt properly.

  1. Adjust the seat, if the seat is adjustable, so you can sit up straight. To see how, see "Seats" in the Index.

Lap-Shoulder Belt

  1. Pick up the latch plate and pull the belt across you. Do not let it get twisted.

    The lap-shoulder belt may lock if you pull the belt across you very quickly. If this happens, let the belt go back slightly to unlock it. Then pull the belt across you more slowly.

    If the shoulder portion of a passenger belt is pulled out all the way, the child restraint locking feature may be engaged. See Child Restraint Systems 0 67. If this occurs, let the belt go back all the way and start again. If the locking feature stays engaged after letting the belt go back to stowed position on the seat, move the seat rearward or recline the seat until the shoulder belt retractor lock releases.

    The rear center seat belt can only be withdrawn from the retractor if the seatback is in the upright locked position.

Lap-Shoulder Belt

  1. Push the latch plate into the buckle until it clicks.

Pull up on the latch plate to make sure it is secure. If the belt is not long enough, see Seat Belt Extender

Position the release button on the buckle so that the seat belt could be quickly unbuckled if necessary.

  1. If equipped with a shoulder belt height adjuster, move it to the height that is right for you. See "Shoulder Belt Height Adjuster" later in this section for instructions on use and important safety information.

Lap-Shoulder Belt

  1. To make the lap part tight, pull up on the shoulder belt.

Lap-Shoulder Belt

To unlatch the belt, push the button on the buckle. The belt should return to its stowed position.

Always stow the seat belt slowly.

If the seat belt webbing returns quickly to the stowed position, the retractor may lock and cannot be pulled out. If this happens, pull the seat belt straight out firmly to unlock the webbing, and then release it.

If the webbing is still locked in the retractor, see your dealer.

Before a door is closed, be sure the seat belt is out of the way. If a door is slammed against a seat belt, damage can occur to both the seat belt and the vehicle.

    READ NEXT:

     Shoulder Belt Height Adjuster

    The vehicle has a shoulder belt height adjuster for the driver and front outboard passenger seating positions. Adjust the height so the shoulder portion of the belt is on the shoulder and not falling

     Seat Belt Use During Pregnancy

    Seat belts work for everyone, including pregnant women. Like all occupants, they are more likely to be seriously injured if they do not wear seat belts. A pregnant woman should wear a lap-shoulder b

     Seat Belt Care

    Keep belts clean and dry. Seat belts should be properly cared for and maintained. Seat belt hardware should be kept dry and free of dust or debris. As necessary, exterior hard surfaces and seat belt

    SEE MORE:

     Vibration analysis - hub and/or axle input

    Test Description The numbers below refer to the step numbers on the diagnostic table: 2 This test will determine the effect of turning input on the vibration. 6 This test will determine the effect of an initial heavy torque load on the vibration. 7 Damaged or worn wheel drive shafts may cause a noi

     Airbag System

    The vehicle has the following airbags: A frontal airbag for the driver A frontal airbag for the front outboard passenger A seat-mounted side impact airbag for the driver A seat-mounted side impact airbag for the front outboard passenger A roof-rail airbag for the driver and the passenger

    © 2020-2024 Copyright www.bencore2.com