Buick Encore: Seat Hardware, Trim, and Upholstery - Description and operation
MANUAL SEATS DESCRIPTION
NOTE: Do not attempt to change the designed seat position by altering the designed seat adjuster-to-floor pan anchor provisions or the seat adjuster-to-seat frame anchor provisions. Changing the seat position could affect the performance of the seat system.
This vehicle is equipped with low-backed front seats with separate head restraints and a three-passenger folding rear seat. Split folding rear seat is optional. Seat cushions and seatbacks have formed foam pads, which fit the contours of the full-panel seatback frame assembly and the designed contour of the seat cushion frame. There are no front seat forward or rearward relocation provisions provided at either the seat adjuster-to-seat frame or the seat adjuster-to-floor pan anchor attachments.
READ NEXT:
Seat Heating and Cooling - Diagnostic information and procedures
DTC B1925 OR B2170 (without memory A45): Seat cushion heater sensor
SCHEMATIC WIRING DIAGRAMS
HEATED/COOLED SEAT WIRING SCHEMATICS (ENCORE)
KA1
Fig. 1: KA1
HEATED/COOLED SEAT WIRING SCHEMATICS (Enco
Seat heating and cooling - Repair instructions
FRONT SEAT HEATER CONTROL MODULE REPLACEMENT
Fig. 3: Front Seat Heater Control Module
Front Seat Heater Control Module Replacement
DRIVER OR PASSENGER SEAT BACK CUSHION HEATER REPLACEMENT
Fig.
SEE MORE:
Repair instructions - on vehicle
Transfer case fluid replacement
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Place a suitable drain pan under the transfer case.
Fig. 2: Transfer Case Drain Plugs
NOTE: Both plugs are to be discarded if removed and NEW plugs
installed.
Remove
Diagnostic information and procedures
Brake drum diameter measurement
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
DRUM BRAKE COMPONENT SPECIFICATIONS
Drum Brake Component Specifications
DIAGNOSTIC INFORMATION AND PROCEDURES
BRAKE DRUM DIAMETER MEASUREMENT
Fig. 1: Measuring Brake Drum Diamet
