Buick Encore: Schematic wiring diagrams
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Fastener Tightening Specifications
.jpg)
SCHEMATIC WIRING DIAGRAMS
HORN WIRING SCHEMATICS (ENCORE)
Fig. 1: Horn (Encore)
HORN WIRING SCHEMATICS (Encore)
Horn
Fig. 2: Horn (Encore)
READ NEXT:
Horns - Diagnostic information and procedures
DTC B2750: Horn relay secondary circuit
DIAGNOSTIC CODE INDEX
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Bas
Horns - Repair instructions
HORN REPLACEMENT
Fig. 3: Horn
Horn Replacement
STEERING WHEEL HORN CONTACT REPLACEMENT (ENCORE)
Fig. 4: Steering Wheel Horn Contact (Encore)
Steering Wheel Horn Contact Replacement (Encore)
Horns - Description and operation
HORNS SYSTEM DESCRIPTION AND OPERATION
System Description
The horn system consists of the following components:
HORN fuse
Underhood fuse block (contains PCB horn relay)
Horn switch
Horn-low note
SEE MORE:
Malfunction Indicator Lamp (Check Engine Light - Capped)
This light is part of the vehicle's
emission control on-board
diagnostic system. If this light is on
while the engine is running, a
malfunction has been detected and
the vehicle may require service. The
light should come on to show that it
is working when the ignition is in
Service Mode. See Ignitio
Repair instructions
Tire and wheel removal and installation
Special Tools
CH-41013 Rotor Resurfacing Kit
CH-42450-A Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Remove the wheel cover
© 2020-2025 Copyright www.bencore2.com
