Buick Encore Owners & Service Manuals

Buick Encore: Universal Remote System Operation

Using the Universal Remote System

Press and hold the appropriate Universal Remote system button for at least one-half second. The indicator light will come on while the signal is being transmitted.

Erasing Universal Remote System Buttons

Erase all programmed buttons when vehicle ownership is terminated.

To erase:

  1. Press and hold the two outside buttons until the indicator light begins to flash. This should take about 10 seconds.
  2. Release both buttons.

Reprogramming a Single Universal Remote System Button

To reprogram any of the system buttons:

  1. Press and hold any one of the buttons. Do not release the button.
  2. The indicator light will begin to flash after 20 seconds. Without releasing the button, proceed with Step 1 under "Programming the Universal Remote System."

    READ NEXT:

     Lighting

     Exterior Lighting

     Exterior Lamp Controls

    The exterior lamp control is on the instrument panel to the left of the steering column. There are four positions: : Turns the exterior lamps off and deactivates the AUTO mode. Turn O again to re

    SEE MORE:

     Brake rotor/drum balance inspection

    Support the vehicle drive axle on a suitable hoist. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel assemblies from the drive axle. Refer to Tire and Wheel Removal and Installation . Reinstall the wheel nuts in order to retain the brake rotors. Run the vehicle at the c

     Schematic wiring diagrams

    SPECIFICATIONS FASTENER TIGHTENING SPECIFICATIONS Fastener Tightening Specifications SCHEMATIC WIRING DIAGRAMS ANTILOCK BRAKE SYSTEM WIRING SCHEMATICS (ENCORE) Module Power, Ground and Subsystem References Fig. 1: Module Power, Ground and Subsystem References Wheel Speed Sensors Fig. 2: Wheel

    © 2020-2026 Copyright www.bencore2.com