Buick Encore: Vehicle Load Limits
Buick Encore 2020-2026 Owners Manual / Driving and Operating / Driving Information / Vehicle Load Limits
It is very important to know how much weight the vehicle can carry. This weight is called the vehicle capacity weight and includes the weight of all occupants, cargo, and all nonfactory-installed options.
Two labels on the vehicle may show how much weight it may properly carry, the Tire and Loading Information label and the Certification/Tire label.
Warning
Do not load the vehicle any heavier than the Gross Vehicle Weight Rating (GVWR), or either the maximum front or rear Gross Axle Weight Rating (GAWR).
This can cause systems to break and change the way the vehicle handles. This could cause loss of control and a crash. Overloading can also reduce stopping distance, damage the tires, and shorten the life of the vehicle.
READ NEXT:
Tire and Loading Information
Label
Example Label
vehicle-specific Tire and
Loading Information label is
attached to the center pillar
(B-pillar). The Tire and Loading
Information label shows the
number of occupant seating
positions (
Certification/Tire Label
Label Example
A vehicle-specific Certification/
Tire label is attached to the
center pillar (B-pillar).
The label may show the size of
the vehicle's original tires and
the inflation pressures neede
Starting and Operating
New Vehicle Break-In
Caution
The vehicle does not need an
elaborate break-in. But it will
perform better in the long run if
you follow these guidelines:
Do not drive at any one
constant speed, fa
SEE MORE:
Fasteners
Metric Fasteners
This vehicle provides fastener dimensions using the metric system. Most
metric fasteners are approximate in
diameter to equivalent English fasteners. Make replacements using fasteners of
the same nominal diameter,
thread pitch, and strength.
A number marking identifies the OE met
Plastic Panel Information and Repair - Repair instructions
GENERAL PLASTIC REPAIR
WARNING:
In order to reduce the risk of personal injury when exposed to toxic
fumes
while grinding, cutting, or applying repair material on any type of sheet
molded compound or RIM rigid plastic, observe the following guidelines:
Work in a properly ventilated area
Apply p
© 2020-2026 Copyright www.bencore2.com
