Buick Encore Owners & Service Manuals

Buick Encore: Collision Repair - Visual identification

Buick Encore 2012-2019 Service Manual / Accessories & Equipment / Collision Repair / Collision Repair - Visual identification

STRUCTURE IDENTIFICATION

Fig. 13: Front Structure
Fig. 13: Front Structure

View Front

View Front

View Front

Fig. 14: Rear Structure
Fig. 14: Rear Structure

View Rear

View Rear

View Rear

    READ NEXT:

     Collision repair - Repair instructions

    Front wheelhouse panel replacement Removal Procedure Disable the SIR system. Refer to SIR Disabling and Enabling . Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnec

     Description and operation

    Dual phase steel This information provides repair recommendations and general guidelines for steel classified as Dual Phase Steel (dual phase steel with a tensile strength up to and including 800 MPa

     Cabin Air Filter

    REMOVAL & INSTALLATION NOTE: Manufacturer's terminology for this filter is passenger compartment air filter. CABIN AIR FILTER Removal & Installation Fig. 1: Passenger Compartment Air Filter

    SEE MORE:

     Engine Heater

    Vehicles may have an engine heater. The engine heater can help in cold weather conditions at or below −18 ºC (0 ºF) for easier starting and better fuel economy during engine warm-up. Plug in the heater at least four hours before starting the vehicle. An internal thermostat in the plug end of the

     Horns - Description and operation

    HORNS SYSTEM DESCRIPTION AND OPERATION System Description The horn system consists of the following components: HORN fuse Underhood fuse block (contains PCB horn relay) Horn switch Horn-low note Horn-high note Body control module (BCM) 14 Horns Block Diagram Fig. 6: 14 Horns Block Diagram

    © 2020-2025 Copyright www.bencore2.com