Buick Encore: Rear Window Wiper/Washer
The rear wiper/washer controls are on the end of the windshield wiper lever.
.gif)
ON : Press the upper portion of the button for continuous rear window wipes.
OFF : The rear wiper turns off when the button is returned to the middle position.
INT : Press the lower portion of the button for rear intermittent wipes.
.gif)
REAR : Push the windshield
wiper lever forward to spray washer
fluid on the rear window. The lever
returns to its starting position when
released.
Rear Wiper Arm Assembly Protection
When using an automatic car wash, move the rear wiper control to OFF to disable the rear wiper. In some vehicles, if the transmission is in N (Neutral) and the vehicle speed is very slow, the rear wiper will automatically park under the rear spoiler.
The wiper operations return to normal when the transmission is no longer in N (Neutral) or the vehicle speed has increased.
Reverse Gear Wipes
If the rear wiper control is off, the rear wiper will automatically operate continuously when the shift lever is in R (Reverse), and the front windshield wiper is performing low or high speed wipes. If the rear wiper control is off, the shift lever is in R (Reverse), and the front windshield wiper is performing interval wipes, then the rear wiper automatically performs interval wipes.
This feature can be changed. See Vehicle Personalization
The windshield washer reservoir is used for the windshield and the rear window. Check the fluid level in the reservoir if either washer is not working. See Washer Fluid
READ NEXT:
Compass
The vehicle may have a compass
display in the Driver Information
Center (DIC).
Setting the Compass Zone
Under certain circumstances, such
as during a long trip or moving to a
new area, the compass zon
Power Outlets
Power Outlet 110/120-Volt Alternating Current
If equipped, this power outlet is on
the rear of the center console. It can
be used to plug in electrical
equipment that uses a maximum
limit of 150 watts
SEE MORE:
Jump Starting
Jump Starting - North
America
For more information about the
vehicle battery, see Battery - North
America
If the battery has run down, try to
use another vehicle and some
jumper cables to start your vehicle.
Be sure to use the following steps to
do it safely.
Warning
WARNING: Battery posts,
termina
Camshaft intake and exhaust sprocket replacement
Special Tools
EN-955-A Locking Pin
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the air cleaner assembly. Refer to Air Cleaner Assembly
Replacement .
Remove the camshaft cover. Refer to Camshaft Cover Replacement.
Remove both camshaft position actuator soleno
