Buick Encore: Seat Adjustment
Warning
You can lose control of the
vehicle if you try to adjust a driver
seat while the vehicle is moving.
Adjust the driver seat only when
the vehicle is not moving.
.gif)
To adjust a manual seat:
- Pull the handle at the front of
the seat.
- Slide the seat to the desired
position and release the
handle.
- Try to move the seat back and
forth to be sure it is locked in
place.
Power Seat Adjustment
Warning
The power seats will work with
the ignition off. Children could
operate the power seats and be
injured. Never leave children
alone in the vehicle.
.gif)
To adjust a power seat:
- Move the seat forward or
rearward by sliding the control
forward or rearward.
- Raise or lower the front part of
the seat cushion by moving the
front of the control up or down.
- Raise or lower the entire seat by
moving the rear of the control up
or down.
To adjust the seatback, see
Reclining Seatbacks
To adjust the lumbar support, see
Lumbar Adjustment
READ NEXT:
If available, press the front or rear of
the switch to increase or decrease
lumbar support. Release the switch
when the desired level of support is
reached.
Reclining Seatbacks
Warning
If either sea
If equipped, the MEM, 1, and 2
buttons on the outboard side of the
driver seat are used to manually
save and recall the driver seat and
outside mirror positions. These
manually stored positions are
r
Warning
If temperature change or pain to
the skin cannot be felt, the seat
heater may cause burns. To
reduce the risk of burns, use care when using the seat heater,
especially for long periods of
time
SEE MORE:
Front disc brake pads replacement
Removal Procedure
WARNING: Refer to Brake Dust Warning .
WARNING: Refer to Brake Fluid Irritant Warning .
NOTE: Always replace disc brake pads in axle sets.
Inspect the fluid level in the brake master cylinder reservoir.
If the brake fluid level is midway between
Emissions Related DTCs
Action Taken When the DTC Sets - Type A
The control module illuminates the malfunction indicator lamp (MIL) when
the diagnostic runs and fails.
The control module records the operating conditions at the time the
diagnostic fails. The control module
stores this informat